Colorit - Molerin VP

Characteristics

Resistant to wet cleaning.
High-quality, water-dilutable paint for interior walls. Matt finishing coat. Resistant to wet cleaning (class II EN 13 300). High level of whiteness. Excellent covering power. Good vapour permeability. Easy to use. Ecological paint – very low content of volatile organic compounds.

Substrate Preparation

The substrate should be hard, dry and clean free of dust, grease and oil. Old and loose paint should be removed mechanically. Uneven surfaces should be levelled using GLET C or GLET-P products for interior wall skimming. Before application of MOLERIN VP, walls should be cleaned and impregnated with PODLOGA KONCENTRAT primer (dilution ratio: PODLOGA KONCENTRAT: water=1:3). The drying time of the PODLOGA KONCENTRAT is around 6 hours, after which the application of the first layer of MOLERIN VP may start.

Application

Before its application, MOLERIN VP should be diluted with water (cca. 10-15%) after which the entire volume should be homogenized by mixing to achieve adequate consistency. MOLERIN VP may be tinted by adding POLITON (max. 200 g per 25 kg of paint) and within the Colorit mix system. The second layer of material is applied on the completely dried first layer.

The drying time between the two layers should be from 4 to 6 hours. MOLERIN VP is applied using rollers with short fibres or brushes in at least two layers. To avoid shade variations due to the tying of surfaces, it is necessary to wok without interruptions on wall surfaces. Wash tools with water immediately after use.

Air and wall temperatures during work and drying should be from +10°C up to +30°C, and relative humidity should be under 80%. In case of painting of large surfaces using the same shade, the shade should be equalized in a container that is big enough depending on the quantity of material.