Adhesives for ceramics Colorit

MRAMORFIX

White flexible adhesive

Characteristics

Highly resistant. Water-repellent.
Good-quality white construction adhesive designed for gluing marble, granite, stone, ceramic tiles and similar in indoor and outdoor exploitation conditions. Made on the basis of white cement, mineral fillers and additives. Made on the basis of white cement, mineral fillers and additives.

EN 12004-C2TES1 improved flexible cement -based adhesive with reduced slip and prolonged working time.

Substrate Preparation

Substrate has to be hard, dry, free of dust, grease and other impurities. Before the adhesive is applied, the substrate should be wetted with water or impregnated, if the surface is water-absorbent, with PODLOGA KONCENTRAT product (dilution ratio: PODLOGA KONCENTRAT water=1:3). PODLOGA KVARC product is recommended for smooth surfaces.

Application

Use a 5 kg bag (25 kg) of MRAMORFIX per cca. 1.4 l (6.7 l) of water and mix using a slow-speed mixer until a homogeneous compound is obtained. Leave such material to rest for about 5 minutes and then mix it again. The compound’s working time is around 2-3 hours. Absorbent tiles should be soaked in water before application. Non-absorbent tiles do not need to be soaked in water because that increases slipping and reduces adhesion. In case of installation of new ceramic tiles over old ceramic tiles, the old ceramic tiles’ surface should be roughened first to ensure as good bond as possible.

MRAMORFIX is applied using a notched trowel with notch width of 4 to 6 cm on substrate, after which tiles are laid that should be pressed strongly to obtain at least 60% of adhesion of glue to the tile and at least 90% for outdoor ceramic tiles. The fitting of tiles may be adjusted within 10 minutes after application. If a film is formed on the surface of the adhesive, it should be removed and a new layer of glue should be applied and the tile laid on such glue. Before laying of marble or stone of pale shades, a trial should be performed first to see if there are any changes to the marble or stone colour.

After 24 hours, easy walking on the tiles is possible just like grouting using the selected shade. Expansion joints are to be filled with permanently elastic putty. Optimal air and wall temperatures during work and drying should be from +5°C up to +25°C. Avoid working in direct sun, wind and rain. Use protective sheets during application. Wash tools with water immediately after use.

Consumption

≈ 3 - 5 kg/m2

Packaging

5 kg bags, 200 pieces, 1 pallet = 1000 kg
25 kg bags, 48 pieces, 1 pallet = 1200 kg

Documentation

MRAMORFIX

Consumption calculator

kg

Contact

COLORIT d.o.o.
Blagoja Parovića 114b
78 000 Banja Luka
Republika Srpska, BiH

Tel: +387 51 388 820, 388 830
Fax: +387 51 388 840
Email: info@coloritbl.com

Newsletter

Our products

Fasade.
Unutrašnje boje.
Ljepila za keramiku.
Mase za izravnjavanje i popunjavanje.
Lazurni premazi.
Podloge i impregnacije.
Fasadne boje.
Fasadna ljepila.
Ljepila za parket i drvo.
Hidroizolacije.
Toplotni fasadni sistem.